新聞資訊

公司與國內知名房產單位以及各大建筑單位建立了良好的合作關系,是目前國內專業的金屬、PVC落水系統解決專家

  • 天溝防水屋面怎么樣做
  • 本站編輯:杭州得裕建材有限公司發布日期:2019-12-10 20:26 瀏覽次數:

1、施工作業條件 水落口杯要先安裝好;杯口面標高要比天溝底的找平層低30mm。水落口杯與基層接觸處的縫隙,用配合比為1:2:2的水泥:砂:紉細子的細石混凝土灌筑密實。

2、天溝、檐溝的防水層施工應先把天溝、檐溝基層清理干凈,有銹蝕的地方要打磨出鋼板原有的顏色。清理干凈后做防水保護,用金屬屋面防水涂料進行一布三涂的防水處理, 待防水涂料干燥后,進行試水實驗。

3、注意事項 , 為防止溝內水落口堵塞溢水而向內檐灌水、檐溝外邊的上口不宜高于內檐,如必須高于內檐溝,則在檐溝外邊設溢水孔。 高低跨內排水天溝與立墻交接處,用有變形能力的鍍鋅薄鐵板。

2-1G01G11103[1].jpg

1. In the working conditions, the beaker should be installed first, and the height of the beaker should be 30mm lower than the leveling layer at the bottom of the gutter. The gap between the Water Falling Cup and the base is filled with 1:2:2 cement: Sand: fine stone concrete. 2, Gutter, gutter waterproof layer construction should be the gutter, Gutter grass-roots clean, there is rust to Polish out the original color of the steel plate. After cleaning, waterproof protection is done, one cloth and three coating waterproof treatment is carried out with metal roofing waterproof coating. After the waterproof coating is dried, water test is carried out. 3. Points to note: In order to prevent the overflow from being blocked by the water drop in the ditch, the water should be poured into the inner eaves. The outer top of the EAVES ditch should not be higher than the inner eaves. If it must be higher than the inner eaves ditch, the overflow hole should be set outside the eaves ditch. The junction of high and low span inner drainage gutter and Vertical Wall is made of galvanized iron sheet with deformability.

杭州得裕建材有限公司

地? 址:杭州市余杭區余杭鎮義橋工業園區?

手? 機:13758137262 ( 喬經理 )

座? 機:0571-56017206

傳? 真:0571-85853340

永利棋牌每天送九个金币 投资和股票一个样么 辽宁快乐12软件下载 内蒙古十一选五最大遗漏 快乐双彩好运开奖结果 黑龙江11选5走势图 三大股票指数 山东十一选五的开奖 内蒙古期货股票配资 陕西快乐10分最大遗漏 徐州股票配资公司